Jentra Channel Liner Tool for Glock Gen 1-5 All Models
The Jentra Channel Liner Tool will work with ALL GEN 1-5 Glock models and is a necessity for any Glock Armorer or shooters toolbox. This is the perfect tool for installing & removing the Channel Liner from the pistol slide. This device is calibrated so the channel liner is installed perfectly each time. The Glock slide firing pin channel has a part installed in it which is called the channel liner, This is a tubular shaped plastic liner. Its function is to reduce wear on the firing pin spring and spring cups. When it needs to be replaced from wear, damage, or when the slide is refinished, this tool will easily remove and replace the channel liner.
- Made to a precise dimension.
- Easy to use.
- Will not damage the slide.
- Easily removes & installs channel liner in Glock slides
- This channel liner tool is made from premium grade stainless steel.
Remove: To remove simply screw-threaded end into the liner, place an OEM armorer's tool or similar tool through the hole in the liner tool and simply pull the liner out.
Install: To install, place the new liner on the unthreaded end of the tool (unbeveled end of liner goes on the tool first), then simply push the new liner into slide channel until it seats at the breech end of the channel.
Note: NDZ always recommends any part be installed by a qualified and trained gunsmith. NDZ promotes the use or safety practices and gear when working on any firearm.